Termiroll Labels for iDPRT Printers
Works with iDPRT SP410, SP420, SP450 and other iDPRT 4 inch direct thermal printers.
iDPRT's SP series prints on standard direct thermal media up to 4.1 inches wide, with automatic label calibration on loading. Every Termiroll format, from 4x6 shipping labels to 2x1 barcode rolls, is inside that spec.
The 1.5 inch core sits in the internal holder, and fanfold stacks feed through the rear slot. No ribbon, no ink and no brand lock: the printer just needs well die-cut direct thermal labels, which is what these are.
Setup tips
- Let the intelligent calibration run when you load a new size; it measures the label automatically.
- Keep the transparent media guides snug against the roll edge to avoid drift on long batches.
- For glossy scan-heavy barcodes, one step up on density in the driver sharpens thin bars.
Formats that fit a iDPRT printer
- 2x1 Thermal Labels — Single roll, 1,000 labels; 10-roll pack, 10,000 labels
- 3x2 Thermal Labels — Single roll, 500 labels
- 4x3 Thermal Labels — Single roll, 500 labels; 12-roll case, 6,000 labels
- 4x6 Thermal Shipping Labels — Roll, 350 labels; Fanfold stack, 130 labels; Fanfold stack, 500 labels
Every format above runs in the iDPRT models listed at the top of this page. Side by side, with what each size is best for, they are on the printer compatibility hub.
Model not listed? If it is a 4 inch direct thermal printer that takes die-cut labels, it almost certainly fits. Confirm at support@termiroll.us.