Termiroll Labels for MUNBYN Printers

Works with MUNBYN ITPP941, ITPP129, P130 series and other MUNBYN 4 inch direct thermal printers.

MUNBYN's desktop label printers are built for exactly this media: 4 inch direct thermal labels with gaps between them. Termiroll 4x6 rolls and fanfold stacks feed straight in, and the smaller 4x3, 3x2 and 2x1 formats run with the side guides adjusted.

MUNBYN printers hold cores from 1 to 3 inches, so the 1.5 inch Termiroll core fits without adapters. The printer's automatic calibration handles label length on first feed.

Setup tips

• Hold the feed button for the calibration cycle whenever you switch formats.
• Use the external holder or the rear slot for fanfold stacks so labels enter flat.
• If the first label after loading prints offset, run one more calibration pass; it aligns on the gap.

Formats that fit a MUNBYN printer

• 2x1 Thermal Labels — Single roll, 1,000 labels; 10-roll pack, 10,000 labels
• 3x2 Thermal Labels — Single roll, 500 labels
• 4x3 Thermal Labels — Single roll, 500 labels; 12-roll case, 6,000 labels
• 4x6 Thermal Shipping Labels — Roll, 350 labels; Fanfold stack, 130 labels; Fanfold stack, 500 labels

Every format above runs in the MUNBYN models listed at the top of this page. Side by side, with what each size is best for, they are on the printer compatibility hub.

Model not listed? If it is a 4 inch direct thermal printer that takes die-cut labels, it almost certainly fits. Confirm at support@termiroll.us.